vertical pressure meaning in Chinese
垂直压力
竖向压力
Examples
- Vertical pressure tanks for air pressure generating stations in electrical switching plants
电气开关厂的空气压力发生站用的立式压力容器 - According to the moving characteristics of tracklayer , when the vehicle is on ramp and the ground ' s vertical pressure is linear , the calculating formulas of relationship between the deviation of the instantaneous steering center , the position of vehicle ' s gravity , steering radius , moving velocity , moving acceleration , and vehicle ' s orientation , were obtained by the theory and method of vector analysis in mathematics and mechanics
摘要根据履带式车辆的运动特点，运用数力学中矢量分析理论和方法，推导了接地比压为线性分布时履带式车辆在斜坡上转向时，瞬时转向中心偏移量与车辆重心位置、转向半径、行进速度、加速度、车辆方位相互关系的计算公式。 - With the help of this program , this paper does research on the moved backwards of the slide surface , lengthening the anchor section , the soil nail ' s total force , gets conclusion about relations between the soil nail ' s length and the slope ' s grade , height , soil ' s mechanical parameter ; relations between soil nail ' s total force and coulomb soil pressure . with the help of the large multiuse finite element program ansys , this paper analyzes the soil nailing in one - step ' s slopes , in two - steps " slopes , puts the emphasis on the axis force ' s distributing along the soil nail at each rows , the effect of both the excavating mode and the original slope figure to the axis force of the soil nail , the one another effect between the upper - step slope and the nether - step slope in the soil nail ' s axis force , gets conclusion about the design of soil nail at the first low , different slope body is the same with different excavating mode , the original slope figure has more effect to some than others because of the slope body , the reasonably design of the step width in two - steps slopes , the two - steps excavating and retaining has more virtue than the one - step ' s . through soil pressure analysis this paper does research on the differences and the links between the coulomb soil pressure theory and the rankin ' s , the vertical pressure at the slope surface when the slope surface is inclined and the retaining wall is rough , the soil pressure ' s distributing behind the panel , gets conclusion about the effect of both the slope body inner stability and the slope surface local stability to the soil pressure
通过分析比较，论证了对数螺旋线型比圆弧形作为边坡的假设滑裂面具有较多的工程优点，并为此编制了一个采用极限平衡法分析土钉支护的fortran语言程序，以此作工具对滑裂面的后移、土钉锚固段的超长、土钉总力的大小等方面作了研究，得出了有关土钉的长度与边坡的坡角、坡高、土体力学参数的关系、土钉总力与库仑土压力间的关系等结论；采用大型通用有限元数值分析程序ansys分别对采用土钉支护的一阶边坡、二阶边坡进行分析，重点是研究各排土钉的轴力分布规律、开挖方式及原始边坡形态对土钉的轴力的影响、上下阶边坡在土钉轴力方面的相互作用，得出了有关第一排土钉的设计问题、不同类型的土体应适用于特定的开挖方式、原始开挖出的边坡形态对一些类型坡体的边坡土钉支护有较大的影响而对另外一些影响不大、二阶边坡台阶宽度的合理确定、二阶开挖及支护比一阶时具有较多的工程优点等结论；通过土压力分析对朗肯、库仑两种经典土压力理论的区别与联系、坡面倾斜及墙背有摩擦时的坡面竖向应力分布、面板背土压力的分布形态作了研究，得出了边坡支挡土压力受坡体内部稳定与坡面局部稳定两个方面的影响、土钉支护面板背土体中卸荷拱的存在对面板受力有利等结论。 - Through the fem calculation and the analyzing data of the field , the result is that the central wall mainly endures the vertical pressure from the structure transferring and its bending moment is relatively less and its position of the maximum value of the bending moment locates in the joint between the central wall and the steel framework
通过有限元计算和对现场监控量测数据的分析，论文得出：中隔墙主要承受结构传递的竖向压力，弯矩值较小；钢拱架的轴力以受压为主，弯矩值在中隔墙上方位置处最大。 - Based on the experiment of full - sized cshb walls under lateral and vertical loads , initial crack - resisting stiffen formula was deduced by considering the influence of concrete beams , concrete core columns , structural columns , vertical pressure and window ( or door ) . the results calculated from the formula were fit well with the experimental results . by the analysis of displacement at initial crazing , probability statistical mode and its parameters of relative displacement angle were presented
在介绍和总结本课题的室内足尺寸单片墙抗侧力性能试验的基础上，考虑了圈梁、芯柱、构造柱和墙体正压力、开门窗洞等因素对抗侧刚度的影响，提出了综合各种因素的初裂抗侧刚度公式，与试验结果具有很好的一致性；结合试验的初裂位移分析，给出了层间相对位移角的概率统计模式及相应的统计参数，提出了小砌块建筑层间位移角的控制标准。